Seazoon Capacitive Touch dimmer PWM Control Panel dimmer Switch Module Oc122

Seazoon Capacitive Touch dimmer PWM Control Panel dimmer Switch Module Oc122. Light levels can be adjusted according to need, a wide range of options, easy operation 。 Application voltage range, can arbitrarily choose between 2.4 ~ 4.5V 。 Application circuit is simple, less peripheral devices, easy processing and low cost 。 Installation: No direct contact copper, may across more than 3mm acrylic glass or plastic dimming 。 Dimming mode: PWM stepless dimming 。 Smart Electronics Capacitive Touch Dimmer Constant Pressure Stepless Dimming PWM Control Panel Type LED Dimmer Switch Module。 1. Light levels can be adjusted according to need, a wide range of options, easy operation.。 2. Available under medium (such as glass, acrylic, plastic, ceramic, etc.) to achieve isolation protection case touch functionality and high security.。 3. Application voltage range, can arbitrarily choose between 2.4 ~ 4.5V.。 4. Application circuit is simple, less peripheral devices, easy processing and low cost.。 5. Anti-power interference and interference characteristics of a good phone. EFT can reach ± 2KV above; close, multi-angle cell phone interference, Touch response sensitivity and reliability is not affected.。 6. Installation: No direct contact copper, may across more than 3mm acrylic glass or plastic dimming.。 7. Uses: LED modules can be controlled, with lights and other products. Suitable for indoor lamp, LED lighting dimmer, DIY lights dimming refit the best accessories.。 8. Function: singlet touch, use capacitive touch principle, namely the induction sensitive fingertips. The default is a switching function, dimming function with brightness memory slowly fades the LED touch stepless dimming function. When the lights brighten slowly, slowly dimmed lights, effectively avoiding eye irritation.。 9. dimming mode: PWM stepless dimming。 10. Wiring: PCB board (VCC, GND) for power input, (LED +, LED-) to connect the LED sign level (fingerprint) to access the touch area, but also the wiring leads (note the wiring is not too long, outlet Available with a small piece of copper after doing the sensing area), copper area suggestions about 2x3cm. Board carrying a copper foil side of the copper foil attached to the module shell side.。 11. Use lit a) tap the touch (touch duration is less than 550ms), you can achieve control lights off. One-click touch, lights; again tap the touch, the lamp is off. Illumination lightin 。 。 。

Seazoon Capacitive Touch dimmer PWM Control Panel dimmer Switch Module Oc122
Seazoon Capacitive Touch dimmer PWM Control Panel dimmer Switch Module Oc122
Seazoon Capacitive Touch dimmer PWM Control Panel dimmer Switch Module Oc122